gpio_params.h
Go to the documentation of this file.
1 /*
2  * Copyright (C) 2020 Bruno Chianca <brunobcf@gmail.com>
3  *
4  * This file is subject to the terms and conditions of the GNU Lesser
5  * General Public License v2.1. See the file LICENSE in the top level
6  * directory for more details.
7  */
8 
20 #ifndef GPIO_PARAMS_H
21 #define GPIO_PARAMS_H
22 
23 #include "board.h"
24 #include "saul/periph.h"
25 
26 #ifdef __cplusplus
27 extern "C" {
28 #endif
29 
34 {
35  {
36  .name = "LD 1",
37  .pin = LED0_PIN,
38  .mode = GPIO_OUT,
40  },
41  {
42  .name = "SW 1",
43  .pin = BTN0_PIN,
44  .mode = GPIO_IN_PU,
45  .flags = SAUL_GPIO_INVERTED,
46  },
47 };
48 
49 #ifdef __cplusplus
50 }
51 #endif
52 
53 #endif /* GPIO_PARAMS_H */
54 
saul_gpio_params
static const saul_gpio_params_t saul_gpio_params[]
LED and button configuration for SAUL.
Definition: gpio_params.h:33
board.h
Board specific configuration for Adafruit ItsyBitsy nRF52840.
periph.h
Parameter definitions for mapping peripherals directly to SAUL.
GPIO_OUT
@ GPIO_OUT
configure as output in push-pull mode
Definition: gpio.h:122
GPIO_IN_PU
@ GPIO_IN_PU
configure as input with pull-up resistor
Definition: gpio.h:121
saul_gpio_params_t::name
const char * name
name of the device connected to this pin
Definition: periph.h:52
SAUL_GPIO_INIT_CLEAR
@ SAUL_GPIO_INIT_CLEAR
set pin inactive after init
Definition: periph.h:44
saul_gpio_params_t
Direct mapped GPIO configuration values.
Definition: periph.h:51
SAUL_GPIO_INVERTED
@ SAUL_GPIO_INVERTED
pin is used as inverted
Definition: periph.h:43