gpio_params.h
Go to the documentation of this file.
1 /*
2  * Copyright (C) 2015 Freie Universität Berlin
3  *
4  * This file is subject to the terms and conditions of the GNU Lesser
5  * General Public License v2.1. See the file LICENSE in the top level
6  * directory for more details.
7  */
8 
19 #ifndef GPIO_PARAMS_H
20 #define GPIO_PARAMS_H
21 
22 #include "board.h"
23 #include "saul/periph.h"
24 
25 #ifdef __cplusplus
26 extern "C" {
27 #endif
28 
32 static const saul_gpio_params_t saul_gpio_params[] =
33 {
34  {
35  .name = "LED(red)",
36  .pin = LED0_PIN,
37  .mode = GPIO_OUT,
38  .flags = SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR,
39  },
40  {
41  .name = "LED(green)",
42  .pin = LED1_PIN,
43  .mode = GPIO_OUT,
44  .flags = SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR,
45  },
46  {
47  .name = "LED(orange)",
48  .pin = LED2_PIN,
49  .mode = GPIO_OUT,
50  .flags = SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR,
51  },
52 };
53 
54 #ifdef __cplusplus
55 }
56 #endif
57 
58 #endif /* GPIO_PARAMS_H */
59 
periph.h
Parameter definitions for mapping peripherals directly to SAUL.
GPIO_OUT
@ GPIO_OUT
configure as output in push-pull mode
Definition: gpio.h:122
saul_gpio_params_t::name
const char * name
name of the device connected to this pin
Definition: periph.h:52
SAUL_GPIO_INIT_CLEAR
@ SAUL_GPIO_INIT_CLEAR
set pin inactive after init
Definition: periph.h:44
saul_gpio_params_t
Direct mapped GPIO configuration values.
Definition: periph.h:51
saul_gpio_params
static const saul_gpio_params_t saul_gpio_params[]
LED configuration.
Definition: gpio_params.h:32
SAUL_GPIO_INVERTED
@ SAUL_GPIO_INVERTED
pin is used as inverted
Definition: periph.h:43