Support for the nRF52840-Dongle. More...

Detailed Description

Support for the nRF52840-Dongle.

General information

The nRF52840-Dongle is a bare USB-stick shaped device that houses barely anything than the nRF52840 itself, which offers BLE and 802.15.4 and USB connectivity.

Unlike similar sticks (like the nRF52840-MDK), it features no dedicated programmer hardware but relies on direct USB communication with a built-in bootloader.

The board features two LEDs (LD1: green, LD2: RGB), a user (SW1) and a reset button as well as 15 configurable external pins.

Links

Flash the board

The board is flashed using its on-board boot loader; the nrfutil program needs to be installed. That can turn the binary into a suitable zip file and send it to the bootloader.

The process is automated in the usual make flash target.

If RIOT is already running on the board, it will automatically reset the CPU and enter the bootloader. If some other firmware is running or RIOT crashed, you need to enter the bootloader manually by pressing the board's reset button.

Readiness of the bootloader is indicated by LD2 pulsing in red.

nrfutil installation

On systems with Python 2 available, pip install nrfutil works.

On systems with Python 3, a recent version of pip is required to install all dependencies; you may need to run pip install --upgrade pip before being able to run pip install nrfutil successfully.

Accessing STDIO

The usual way to obtain a console on this board is using an emulated USB serial port (CDC-ACM). This is available automatically using the stdio_cdc_acm module, unless any other stdio module is enabled.

On Linux systems with ModemManager < 1.10 installed, make term will, in some setups, fail for a few seconds after the device has come up. This is fixed in its 1.12.4 version, but should not be more than a short annoyance in earlier versions.

To ease debugging, pins 0.13 and 0.15 are configured as RX and TX, respectively. They provide stdio if no CDC-ACM is disabled, and can be used as a custom UART otherwise.