STM32 Nucleo-F030R8
Support for the STM32 Nucleo-F030R8. More...
Detailed Description
Support for the STM32 Nucleo-F030R8.
Overview
The Nucleo-F030R8 is a board from ST's Nucleo family supporting a ARM Cortex-M0 STM32F030R8 microcontroller with 8Kb of SRAM and 64Kb of ROM Flash.
Hardware
MCU
| MCU | STM32F030R8 |
|---|---|
| Family | ARM Cortex-M0 |
| Vendor | ST Microelectronics |
| RAM | 8KiB |
| Flash | 64KiB |
| Frequency | up to 48MHz |
| FPU | no |
| Timers | 10 (2x watchdog, 1 SysTick, 7x 16-bit) |
| ADCs | 1x 12-bit |
| UARTs | 2 |
| SPIs | 2 |
| I2Cs | 2 |
| RTC | 1 |
| Vcc | 2.4V - 3.6V |
| Datasheet | Datasheet |
| Reference Manual | Reference Manual |
| Programming Manual | Programming Manual |
| Board Manual | Board Manual |
Implementation Status
| Device | ID | Supported | Comments |
|---|---|---|---|
| MCU | STM32F030R8 | partly | Energy saving modes not fully utilized |
| Low-level driver | GPIO | yes | |
| PWM | yes (4 pins available) | ||
| UART | 2 UARTs | USART2 via STLink/USB or D0(RX)/D1(TX) and USART1 on PA10(RX)/PA09(TX) | |
| ADC | 6 pins | ||
| I2C | no | ||
| SPI | no | ||
| USB | no | ||
| Timer | 3 16 bit timers |
Flashing the device
The ST Nucleo-F030R8 board includes an on-board ST-LINK V2 programmer. The easiest way to program the board is to use OpenOCD. Once you have installed OpenOCD (look here for installation instructions), you can flash the board simply by typing
make BOARD=nucleo-f030r8 flash
and debug via GDB by simply typing
make BOARD=nucleo-f030r8 debug
Supported Toolchains
For using the ST Nucleo-F030R8 board we strongly recommend the usage of the GNU Tools for ARM Embedded Processors toolchain.
Files | |
| file | periph_conf.h |
| Peripheral MCU configuration for the nucleo-f030r8 board. | |
