STM32 Nucleo-F070RB
Support for the STM32 Nucleo-F070RB. More...
Detailed Description
Support for the STM32 Nucleo-F070RB.
Overview
The Nucleo-F070RB is a board from ST's Nucleo family supporting a ARM Cortex-M0 STM32F070RB microcontroller with 16Kb of SRAM and 128Kb of ROM Flash.
Hardware
MCU
| MCU | STM32F070RB |
|---|---|
| Family | ARM Cortex-M0 |
| Vendor | ST Microelectronics |
| RAM | 16KiB |
| Flash | 128KiB |
| Frequency | up to 48MHz |
| FPU | no |
| Timers | 11 (2x watchdog, 1 SysTick, 8x 16-bit) |
| ADCs | 1x 12-bit (16 channels) |
| UARTs | 4 |
| SPIs | 2 |
| I2Cs | 2 |
| RTC | 1 |
| USB | 1 |
| Vcc | 2.4V - 3.6V |
| Datasheet | Datasheet |
| Reference Manual | Reference Manual |
| Programming Manual | Programming Manual |
| Board Manual | Board Manual |
Implementation Status
| Device | ID | Supported | Comments |
|---|---|---|---|
| MCU | STM32F070RB | partly | Energy saving modes not fully utilized |
| Low-level driver | GPIO | yes | |
| PWM | yes (4 pins available) | ||
| UART | 3 UARTs | USART2 via STLink/USB or D0(RX)/D1(TX), USART1 on PA10(RX)/PA09(TX) and USART3 on PC11(RX)/PC10(TX) | |
| ADC | 6 pins | ||
| I2C | no | ||
| SPI | no | ||
| USB | no | ||
| Timer | 3 16 bit timers |
Flashing the device
The ST Nucleo-F070RB board includes an on-board ST-LINK V2 programmer. The easiest way to program the board is to use OpenOCD. Once you have installed OpenOCD (look here for installation instructions), you can flash the board simply by typing
make BOARD=nucleo-f070rb flash
and debug via GDB by simply typing
make BOARD=nucleo-f070rb debug
Supported Toolchains
For using the ST Nucleo-F070RB board we strongly recommend the usage of the GNU Tools for ARM Embedded Processors toolchain.
Files | |
| file | periph_conf.h |
| Peripheral MCU configuration for the nucleo-f070rb board. | |
