STM32 Nucleo-L476RG

Support for the STM32 Nucleo-L476RG. More...

Detailed Description

Support for the STM32 Nucleo-L476RG.

MCU

MCU	STM32L476RG
Family	ARM Cortex-M4
Vendor	ST Microelectronics
RAM	128Kb
Flash	1MB
Frequency	up to 80MHz
FPU	yes
Timers	16 (2x watchdog, 1 SysTick, 6x 16-bit, 2x 32-bit [TIM2])
ADCs	1x 12-bit
UARTs	3 (two UARTs and one Low-Power UART)
SPIs	3
I2Cs	3
RTC	1
CAN	1
Vcc	1.71 V - 3.6V
Datasheet
Reference Manual	Reference Manual
Programming Manual	Programming Manual
Board Manual	Board Manual

Flashing the device

The ST Nucleo-L476RG board includes an on-board ST-LINK V2 programmer. The easiest way to program the board is to use OpenOCD. Once you have installed OpenOCD (look here for installation instructions), you can flash the board simply by typing

make BOARD=nucleo-l476rg flash

and debug via GDB by simply typing

make BOARD=nucleo-l476rg debug

Supported Toolchains

For using the ST Nucleo-L476RG board we strongly recommend the usage of the GNU Tools for ARM Embedded Processors toolchain.

Files
file	periph_conf.h
	Peripheral MCU configuration for the nucleo-l476rg board.