Support for the Ublox C030-U201 board. More...

Detailed Description

Support for the Ublox C030-U201 board.

Files
file	arduino_pinmap.h
	Mapping from MCU pins to Arduino pins.

file	board.h
	Board specific definitions for the Ublox C030-U201 board.

file	gpio_params.h
	Board specific configuration of direct mapped GPIOs.

file	periph_conf.h
	Peripheral MCU configuration for the Ublox C030-U201 board.

Functions
void	board_init (void)
	Initialize board specific hardware, including clock, LEDs and std-IO.

LED pin definitions and handlers
#define	LED0_PIN GPIO_PIN(PORT_E, 3)

#define	LED0_MASK (1 << 3)

#define	LED0_ON (GPIOE->BSRR = LED0_MASK)

#define	LED0_OFF (GPIOE->BSRR = (LED0_MASK << 16))

#define	LED0_TOGGLE (GPIOE->ODR ^= LED0_MASK)

#define	LED1_PIN GPIO_PIN(PORT_E, 4)

#define	LED1_MASK (1 << 4)

#define	LED1_ON (GPIOE->BSRR = LED1_MASK)

#define	LED1_OFF (GPIOE->BSRR = (LED1_MASK << 16))

#define	LED1_TOGGLE (GPIOE->ODR ^= LED1_MASK)

#define	LED2_PIN GPIO_PIN(PORT_E, 1)

#define	LED2_MASK (1 << 1)

#define	LED2_ON (GPIOE->BSRR = LED2_MASK)

#define	LED2_OFF (GPIOE->BSRR = (LED2_MASK << 16))

#define	LED2_TOGGLE (GPIOE->ODR ^= LED2_MASK)

si7034 temperature sensor configuration
TODO: Check this when support is added in si70xx driver
#define	SI70XX_PARAM_I2C_DEV I2C_DEV(1)

#define	SI70XX_PARAM_ADDR (0x70)

#define	SI70XX_SAUL_INFO { .name = "si7034" }

SDCard configuration
#define	SDCARD_SPI_PARAM_SPI SPI_DEV(0)

#define	SDCARD_SPI_PARAM_CS GPIO_PIN(PORT_E, 11)

#define	SDCARD_SPI_PARAM_CLK GPIO_PIN(PORT_E, 2)

#define	SDCARD_SPI_PARAM_MOSI GPIO_PIN(PORT_E, 6)

#define	SDCARD_SPI_PARAM_MISO GPIO_PIN(PORT_E, 5)

Modem/GPS pins
#define	UB_PWRON_PIN GPIO_PIN(PORT_E, 14)

#define	UB_M_RST_PIN GPIO_PIN(PORT_B, 5)

#define	M_GPIO2_PIN GPIO_PIN(PORT_D, 1)

#define	M_GPIO3_PIN GPIO_PIN(PORT_B, 4)

#define	GPS_RST_PIN GPIO_PIN(PORT_C, 10) /* Not connected */

Files