AT86RF215 driver compile configuration

Detailed Description

Macros
#define	CONFIG_AT86RF215_USE_CLOCK_OUTPUT
	Set to 1 if the clock output of the AT86RF215 is used as a clock source on the board. More...
#define	CONFIG_AT86RF215_TRIM_VAL   (0)
	Trim value for the external crystal oscillator. More...
#define	CONFIG_AT86RF215_DEFAULT_TXPOWER   (CONFIG_IEEE802154_DEFAULT_TXPOWER)
	Default TX power (0dBm)

Channel configuration
#define	CONFIG_AT86RF215_DEFAULT_CHANNEL   (CONFIG_IEEE802154_DEFAULT_CHANNEL)
#define	CONFIG_AT86RF215_DEFAULT_SUBGHZ_CHANNEL   (CONFIG_IEEE802154_DEFAULT_SUBGHZ_CHANNEL)

Enable Reduced Power Consumption
#define	CONFIG_AT86RF215_RPC_EN   (0)

Default PHY Mode
#define	CONFIG_AT86RF215_DEFAULT_PHY_MODE   (IEEE802154_PHY_OQPSK)

Default O-QPSK Rate Mode
Non-zero value enables proprietary high data rate by default
#define	CONFIG_AT86RF215_DEFAULT_OQPSK_RATE   (0)

Default MR-O-QPSK Chip Rate
#define	CONFIG_AT86RF215_DEFAULT_MR_OQPSK_CHIPS   (AT86RF215_FCHIP_1000)

Default MR-O-QPSK Rate Mode
#define	CONFIG_AT86RF215_DEFAULT_MR_OQPSK_RATE   (2)

Default MR-OFDM Option
#define	CONFIG_AT86RF215_DEFAULT_MR_OFDM_OPT   (2)

Default MR-OFDM Modulation & Coding Scheme
#define	CONFIG_AT86RF215_DEFAULT_MR_OFDM_MCS   (2)

Default MR-FSK Symbol Rate
#define	CONFIG_AT86RF215_DEFAULT_MR_FSK_SRATE   FSK_SRATE_200K

Default MR-FSK Modulation Index, fraction of 64
#define	CONFIG_AT86RF215_DEFAULT_MR_FSK_MOD_IDX   (64)

Default MR-FSK Modulation Order
#define	CONFIG_AT86RF215_DEFAULT_MR_FSK_MORD   FSK_MORD_4SFK

Default MR-FSK Forward Error Correction Scheme
#define	CONFIG_AT86RF215_DEFAULT_MR_FSK_FEC   IEEE802154_FEC_NONE

Macro Definition Documentation

CONFIG_AT86RF215_TRIM_VAL

#define CONFIG_AT86RF215_TRIM_VAL   (0)

Trim value for the external crystal oscillator.

     Each increment adds 300nF capacitance between the crystal oscillator pins
     TCXO and XTAL2.

     Range: 0..15

     Use in conjunction with @see CONFIG_AT86RF215_USE_CLOCK_OUTPUT and a frequency
     meter connected to the clock output pin of the AT86RF215.
     Tweak the value until the measured clock output matches 26 MHz the best.

Definition at line 101 of file at86rf215.h.

CONFIG_AT86RF215_USE_CLOCK_OUTPUT

#define CONFIG_AT86RF215_USE_CLOCK_OUTPUT

Set to 1 if the clock output of the AT86RF215 is used as a clock source on the board.

Otherwise it is turned off to save energy.

Definition at line 85 of file at86rf215.h.